Chevy/GMC 6.2L and 6.5L Discussion of Chevy and GMC Trucks with 6.2L and 6.5L Diesel Engines

no power and black smoke

  #1  
Old 07-12-2013, 04:23 PM
justrucs's Avatar
Newbie
Thread Starter
Join Date: Jul 2013
Posts: 4
Likes: 0
Received 0 Likes on 0 Posts
Default no power and black smoke

If the pedal is touched the rpms race up.After a while the engine will run normal until it goes uphill or at a quick start will smoke up.At 50 -55 it will not generally hold,instead it will fluctuate up and down quickly.Does anyone have a suggestion?
 
  #2  
Old 07-12-2013, 08:17 PM
Mase's Avatar
Diesel Enthusiast
Join Date: Feb 2013
Location: Indiana
Posts: 219
Received 6 Likes on 6 Posts
Default

PMD?Boost sensor?
 
  #3  
Old 07-12-2013, 10:12 PM
racer55's Avatar
Diesel Bomber
Join Date: Oct 2012
Location: Scugog Island ONT.
Posts: 1,848
Likes: 0
Received 103 Likes on 103 Posts
Default

PMD or IP failing is the most common reason for those symptoms.

Flight systems PMD's often fail in that manner and can cause a runaway engine,any PMD not marked STANADYNE is a flight systems no matter what it is badge'd as.
 
  #4  
Old 07-14-2013, 07:03 PM
justrucs's Avatar
Newbie
Thread Starter
Join Date: Jul 2013
Posts: 4
Likes: 0
Received 0 Likes on 0 Posts
Default

Thank you for the quick reply.I am new at diesel engines,could you elaborate what a pmd or Ip is?
 
  #5  
Old 07-14-2013, 07:44 PM
racer55's Avatar
Diesel Bomber
Join Date: Oct 2012
Location: Scugog Island ONT.
Posts: 1,848
Likes: 0
Received 103 Likes on 103 Posts
Default

IP-injection pump

PMD-pump mounted driver or FSD-fuel solenoid driver,this is the black/grey box on the drivers side of the injection pump in stock form.

It is an electronic switchgear that amplifies ECM pulses to a usable current to run the IP fuel solenoid via transistors and other electronics.

They often fail and a common replacement option is to remotely locate it to a location outside the engine bay on an aluminum heatsink with an extension harness.
PMD's fail due to repeated heat cycling breaking internal solder joints that are not user servicable.

The best solution to date is to get them away from external heat sources and to shed the heat they generate when operating to the outside air so that they stay at or near ambient temps at all times.

Often a replacement PMD resistor is required at relocation time due to the difficulty of retrieving the original from the the IP mounted PMD.
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
wiremanWelder357
5.9 Liter CR Dodge Cummins 03-07
3
05-25-2015 09:10 PM
ryank 199
Diesel In Distress - Support Ticket
1
05-14-2015 06:41 PM


Thread Tools
Search this Thread
Quick Reply: no power and black smoke



All times are GMT -5. The time now is 06:14 PM.