Chevrolet / GMC Diesel Tech Articles All years Duramax

Had to replace a Glow Plug so here is some info.

 
Thread Tools
 
Search this Thread
 
  #1  
Old 10-23-2009, 07:25 PM
dozerboy's Avatar
Diesel Wrench
Thread Starter
Join Date: Apr 2007
Location: TX
Posts: 988
Received 55 Likes on 44 Posts
Default Had to replace a Glow Plug so here is some info.

Seems I'm seeing a lot of Glow plug failures on LBZ lately, so I though this might help some. The cylinders are numbered front to back like fords odd on the passenger side even on the drivers. I took the fender liner out to get to them. Others might have to lose the tire too, but I'm small. You can do some of them from underneath aswell. You need to be genital GPs ain't as strong as they look and this area can be heavy corroded for ya'll in the rust belt. Need a 8mm to remove the bolt that holds on the ring terminal. Need to check the resistance from the GP terminal to the block if its over 1 ohm its bad. Its a 12mm wrench or Med/deep well socket. Deep wells won't fit around the steering shaft on #4. I put a little anti seize on the GP just to make sure it doesn't get stuck after I replaced it. Get them good and sung IIRC the TQ was 13lb ft.


GM Part #97364968 for the Glow Plug its a 61G and was $28 at the dealer.

If its not the GP check the ohms of the harness and that its not grounding out. The control module is at the back drivers on the engine. The plug releases by pulling a tab under where the wires are. Pull tab away from the plug while wiggling the plug. I never could get the GPCM to energize the GPs with EFI, so to check that you are getting power you may need a tech2. Even though the the GP light stays on when you have a CEL I don't think they are getting power. So you don't have to worry about burning them up before you get them fixed.

The GPCM is Part #98041624 IIRC ~$120

For some reason the manual says to replace all 8 GPs if the GP is over 1 ohm. Rttoys and I where thinking this is a typo it doesn't make sense.
 
  #2  
Old 10-23-2009, 08:33 PM
Benjamin's Avatar
Bombardier
Join Date: Mar 2007
Location: Da' Dirty South
Posts: 9,655
Received 607 Likes on 502 Posts
Default

thanks for the information.

My thoughts on the if one is bad replace them all is this, they have been cycled all exactly the same ammount of times. if one goes bad today and you replace it, then another goes bad a week from now, then 4 months later 3 go bad, by the time you replace them all you forget which ones were replaced when, so they all have a different lifespan when thinking they all should go bad at about the same time.

if you have a gas truck and one spark plug is bad do you replace the bad one or all eight?
 
  #3  
Old 10-23-2009, 10:11 PM
dozerboy's Avatar
Diesel Wrench
Thread Starter
Join Date: Apr 2007
Location: TX
Posts: 988
Received 55 Likes on 44 Posts
Default

True, but I don't replace good parts. Now if I start seeing what your saying I might do all 8. I keep a log of everything I do to my truck.
 
  #4  
Old 10-26-2009, 12:15 PM
Rttoys's Avatar
Diesel Bomber
Join Date: May 2007
Location: Houston, TX
Posts: 1,221
Received 126 Likes on 88 Posts
Default

Originally Posted by Benjamin
if you have a gas truck and one spark plug is bad do you replace the bad one or all eight?


Parts houses tell you to replace everything in pairs or replace all or nothing. It's their job and that's how they make money.

There is also a big difference in replacing 8 glow plugs @ $28 each (that are not considered a wearable part) and replacing 8 spark plugs @ less than $10 each (that is a wearable part).
 
  #5  
Old 10-26-2009, 06:21 PM
Benjamin's Avatar
Bombardier
Join Date: Mar 2007
Location: Da' Dirty South
Posts: 9,655
Received 607 Likes on 502 Posts
Default

Originally Posted by Rttoys
Parts houses tell you to replace everything in pairs or replace all or nothing. It's their job and that's how they make money.

There is also a big difference in replacing 8 glow plugs @ $28 each (that are not considered a wearable part) and replacing 8 spark plugs @ less than $10 each (that is a wearable part).
good point, never thought of it in that fashion, i've replaced Powerstroke glowplugs all at one time.... i'd rather do it once and wait a few years to do it again then to do it today, do it 2 months from now again, 3 times the next year.... you see the pattern....
 
  #6  
Old 10-26-2009, 06:29 PM
2500HeavyDuty's Avatar
Super Moderator
Join Date: Oct 2007
Location: Houston, Tx
Posts: 14,872
Received 764 Likes on 627 Posts
Default

Originally Posted by Benjamin
good point, never thought of it in that fashion, i've replaced Powerstroke glowplugs all at one time.... i'd rather do it once and wait a few years to do it again then to do it today, do it 2 months from now again, 3 times the next year.... you see the pattern....

duramax plugs are very easy to get to, they are in plain view once the plastic fender liner is removed
 
  #7  
Old 10-26-2009, 07:01 PM
Benjamin's Avatar
Bombardier
Join Date: Mar 2007
Location: Da' Dirty South
Posts: 9,655
Received 607 Likes on 502 Posts
Default

i c, on the 7.3 powerstorke it is under the valve covers..... PITA
 
  #8  
Old 10-26-2009, 08:08 PM
2500HeavyDuty's Avatar
Super Moderator
Join Date: Oct 2007
Location: Houston, Tx
Posts: 14,872
Received 764 Likes on 627 Posts
Default

Originally Posted by Benjamin
i c, on the 7.3 powerstorke it is under the valve covers..... PITA

i hear number 7 is a real pita to get to
 
  #9  
Old 10-26-2009, 08:08 PM
Benjamin's Avatar
Bombardier
Join Date: Mar 2007
Location: Da' Dirty South
Posts: 9,655
Received 607 Likes on 502 Posts
Default

no not really, perty easy if i say so....
 
  #10  
Old 12-23-2009, 09:40 PM
bobcat67's Avatar
Diesel Bomber
Join Date: Dec 2008
Location: Bozeman, MT
Posts: 1,222
Received 140 Likes on 106 Posts
Default

i want cool shoes
 
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Metz1234
Ford 83-94 6.9 and 7.3L General
3
03-03-2016 10:20 PM
D K
Ford Powerstroke 99-03 7.3L
0
05-17-2015 11:27 AM
Texasthb
Ford 83-94 6.9 and 7.3L General
1
03-04-2015 08:20 AM
ajwright64
Ford Powerstroke 99-03 7.3L
0
02-04-2015 09:36 PM
norcal6.5
Chevy/GMC 6.2L and 6.5L
1
12-07-2014 07:04 PM



Quick Reply: Had to replace a Glow Plug so here is some info.



All times are GMT -5. The time now is 11:10 AM.