i was reading on a can of seafoam that you can add it to the oil and it helps keep things cleaned up inside the engine. just wandering if this is a good idea.

psy_6att_6ica_6's Sig:

2001 cummins long box quad cab, 4" turbo back staight pipewith 5" tip, AFE stage 1 intake, BD boost fooler, waste gate closed, TC lockup switch, triple pillar guages, custom stereo, aftermarket head-marker-and taillights, hypertech max energy programmer, 315x75r16 hankook ATMs with 16" aluminum rock crusher wheels, custom heavy duty front bumper. - rv275 injector nozzles soon

seafoam is some good stuff

hotcummins's Sig:

its a 12valve with a few performance adders

I don’t think you should drive it after it’s been added. Come home with it hot add it and let it idle for 20 and then drain the oil right away.

It’s some good stuff.

jessy's Sig:

15 2008 Freightliner dump trucks
7 2000 Mack dump trucks
8 mix and match work trucks

When your ready to do an oil change, dump a can in and drive it around the block and then park it and change the oil and yes it does wonders. But don;t drive any farther then that or let the truck run any longer then that. It works well and will heat up fast and spin bearings if you let it go to long.

It also works well in the fuel but pour it into the tank. When you change the fuel filter, refill the canister with a can of Sea Foam and fire the truck up. Doing it this way runs it all through within seconds and doesn't have time to dry seals and kill the lubricity of the entire tank of fuel.

Uncle Bubba's Sig:

99 Quad Cab, 4wd, Drag Comp W/Pump Wire & Boost Elbow installed, K&N Air Canon, MBRP exhaust, Belt Drive Lift Pump and bottom Bulkhead feed from the tank, Isspro EV Pyrometer, Boost Gauge, Fuel Pressure Gauge, DT Pro Fab Trac Bar, South Bend 13-1.25 Con O Clutch, Ranch Hand Bumper, Borgeson Steering Shaft, Black Silicone Boots, 2" Lift Soft Ride Front Coils, Solenoid High Idle Kit, Bilstein 5100 HD Shocks, Rickson 19.5 Wheels w/Hancoock Rubber, HD Maxx Link Sway Bar Links, Superlift dual front stabilizer, EGR Brakes Front and Back, RV275 Injector's, Blue Chip VP44, Prodigy brake controller, B&W Gooseneck hitch and more I can't remember right now. Not to mention more to come I'm sure.
374.2/846.7 at 30psi

I use it in my snowmobiles.

97cummins's Sig: