HELP HX-40 turbo upgrade
#1
HELP HX-40 turbo upgrade
So im upgrading from a stock Hx-35 turbo to an hx-40 i bought from
Ebay. Its a speedy racers turbo and it cost like 400 bucks. i tried to save some money
it came with a T3 to T4 adaptor and all that, but i have two problems with it.
first of all the waste gate is in the oposite direction of the hx-35 so it faces forwards and its right in the way.
the t4 adaptor makes the large turbo to close to the frame and the fenderwell to get the boost housing to connect anywhere unless its up and i cant have that because i have to get my air filter in there and stuff.
so im thinking. at this point since i cant send the turbo back.. im going to cut and weld
the connecting 45degree piece that connects to the boost housing so that its a couple inches shorter and can connect to receiving hose and not be in the way of the frame, when the turbo boost housing is facing down .
and then, i either have to weld my wastegate shut and get a boost gauge
or somehow attach the hx35 wastegate to the new hx40 and make it face in the oposite direction.
im not really sure what to do at this point. but ive already cut out my exhaust and its been a week so it needs to get done.
What should i do>??? any thoughts ? thankkkks
Ebay. Its a speedy racers turbo and it cost like 400 bucks. i tried to save some money
it came with a T3 to T4 adaptor and all that, but i have two problems with it.
first of all the waste gate is in the oposite direction of the hx-35 so it faces forwards and its right in the way.
the t4 adaptor makes the large turbo to close to the frame and the fenderwell to get the boost housing to connect anywhere unless its up and i cant have that because i have to get my air filter in there and stuff.
so im thinking. at this point since i cant send the turbo back.. im going to cut and weld
the connecting 45degree piece that connects to the boost housing so that its a couple inches shorter and can connect to receiving hose and not be in the way of the frame, when the turbo boost housing is facing down .
and then, i either have to weld my wastegate shut and get a boost gauge
or somehow attach the hx35 wastegate to the new hx40 and make it face in the oposite direction.
im not really sure what to do at this point. but ive already cut out my exhaust and its been a week so it needs to get done.
What should i do>??? any thoughts ? thankkkks
#2
#4
#5
#6
Thread
Thread Starter
Forum
Replies
Last Post
Cdog121
1st Generation Dodge Cummins 89-93
6
11-16-2015 01:49 PM
strokin97
Ford Powerstroke 94-98 7.3L
4
09-30-2014 11:59 PM