Replaced fenders, now won't shift from first?!
#1
Replaced fenders, now won't shift from first?!
Hey guys, recently replaced my rusty front fenders for some rust free fenders but now the truck will not shift out of first gear, any ideas? It has first gear and reverse.Truck is a 2000 24v ext. cab with Auto tranny. Will not shift on its own nor if you help it by doing it.. Checked for bare wires but did not see anything. Any connections I may have missed that would cause this? All works as normal but will not leave first.
---AutoMerged DoublePost---
Also checked for codes and it shows (P done). No codes at all.
Getting frustrating as i drove the truck home last week with no worries, parked it for 3 days while i did the fenders and now all of a sudden it is acting up. Changed out my Tranny Relay with no luck. Any help is greatly appreciated.
---AutoMerged DoublePost---
Also checked for codes and it shows (P done). No codes at all.
Getting frustrating as i drove the truck home last week with no worries, parked it for 3 days while i did the fenders and now all of a sudden it is acting up. Changed out my Tranny Relay with no luck. Any help is greatly appreciated.
Last edited by Obee; 06-24-2012 at 05:13 PM. Reason: Automerged Doublepost
#3
---AutoMerged DoublePost---
So looking further I believe my tranny output shaft speed sensor is buggered. Anybody run into this before?
Last edited by Obee; 06-25-2012 at 06:34 PM. Reason: Automerged Doublepost
#4
#6
Thread
Thread Starter
Forum
Replies
Last Post
cummins1999
24 Valve 2nd Gen Dodge Cummins 98.5-02
0
06-26-2015 01:56 AM
EverettsGMC
5.9 Liter CR Dodge Cummins 03-07
6
03-29-2015 05:42 PM