Need help please! Tranny wont shift
#1
Need help please! Tranny wont shift
I have a 01 cummins auto and it won't shift into overdrive. And its taking off in 3rd gear. I was driving it today and it was fine. Went to drive it couple hours later and I noticed I had to give it a lot of throttle to take off and then it wouldn't shift into OD. Needs some help please. Could it be a fuse or voltage problem?
#4
I doubt the tranny is shot. Its probably taking off in 2nd gear....thats limp mode. Something went wrong to where the computer is trying to protect the truck. You need to get it to a shop and have them check it out. I'm guessing the check engine light is on....any other lights on in the dash???
#5
#6
Could be a few different things if it only happens once it warms up. It could be low fluid, a solenoid thats going bad (the heated fluid could be causing to much resistance), pump is getting to much play.....makes it hard. Might see if you can get someone to pull the codes out of the computer and see if it stored anything. It can store codes and not turn the CEL on. Was the pump replaced when the tranny was overhauled???
#7
#8
#9
Yeah I found the problem. The idiot I bought the truck from had a torque converter lock up switch wired into the computer and had a ground going to a wire on the computer so it was back feeding thru the computer, I cut the wires n boom problem fixed. Some ppl are idiots I tell yeah. Thanks everyone for your help!!!
Thread
Thread Starter
Forum
Replies
Last Post
Frustrateddodgeowner
Tech Article Submission
0
07-06-2015 12:33 AM