converter will not lock up normally
#1
converter will not lock up normally
hey guys, the owner before me wired in one of those converter lock up switches, and i just realized that it will not lock the converter unless i flick the switch. so does wiring in a manual switch to command lock up get rid of it locking up normally when the computer tells it to?
#5
ok so i checked all the wiring, and it was correct except for the jumper lead thats put in place of the trans relay. i put it in the correct spot, and gave it a test run still no lockup unless i flick the switch. and sorry for the week late reply, starter solenoid took a crap, and was waiting on a new one to come in.
#6
#7
if you look at the link, the jumper was in the middle vertical line going to the bottom horizontal line. when i swaped it, it made no difference, and no the wire is T-tapped not cut.
http://www.tstproducts.com/Torque%20...p%20Switch.pdf
http://www.tstproducts.com/Torque%20...p%20Switch.pdf
Thread
Thread Starter
Forum
Replies
Last Post
Cody Cain
24 Valve 2nd Gen Dodge Cummins 98.5-02
0
12-22-2014 01:27 PM
Cody Cain
Diesel In Distress - Support Ticket
0
12-21-2014 06:50 PM