99 cummins clutch install gone wrong
#1
99 cummins clutch install gone wrong
Help needed I just installed a new clutch kit w/ new dodge master and slave cylinder trans went right in no issues there but it will not go in gear while engine is running disk is in corect plate is torqued to 22ft lbs any ideas ? please help need to get back on the road to pay uncle sam
#2
on a bind same thing happened to mine first time i installed take it back out and put it back together little trick i learned is install the clutch/bell housing and slave before tranny have someone push in the clutch so the tranny slides right in much easier. the disk is mostlikely on a bind
#3
Make sure the hydro piston is lined up properly into the receiving cup on the clutch fork. Also on aftermarket hydros there is a black plastic spacer that can be removed to make them work on multiple applications. try removing that spacer and see if that helps. May not be fully disengaging the pressure plate
#4
Thread
Thread Starter
Forum
Replies
Last Post
JoeyMiR
24 Valve 2nd Gen Dodge Cummins 98.5-02
9
02-03-2018 10:05 PM
Cody Cain
24 Valve 2nd Gen Dodge Cummins 98.5-02
0
12-22-2014 01:27 PM
Cody Cain
Diesel In Distress - Support Ticket
0
12-21-2014 06:50 PM