|
|
|
|
|
|
|||||||
| 24 Valve 2nd Gen Dodge Cummins 98.5-02 Discussion of 24 Valve 5.9 Liter Dodge Cummins Diesels with VP44 Injection Pumps |
Alright so here goes. I go down the road say at any steady speed. Once in a while I get total dead pedal just for a couple of seconds. then on the off then on again. check engine light comes on. Reads fault code for ... JOIN NOW TO REMOVE TRACER
 |
|
|
LinkBack | Thread Tools |
|
#1
12-27-2009, 07:38 PM
|
|||||
|
|||||
throttle postion problems
Alright so here goes. I go down the road say at any steady speed. Once in a while I get total dead pedal just for a couple of seconds. then on the off then on again. check engine light comes on. Reads fault code for tps. Tps is changed and same problem. Most of the time now when you are at a steady speed the rpms jump all over the place meaning down and up but never higher then what I have the accelerator pressed. I have had it to a shop they think it is an intermittent wiring issue. I have changed the tps and the alternator tps has also been adjusted checked all battery connections and cleaned them.
 some one please try and help me.
|
|
Registered Members don't see these ads. Register now it's free! |
|
#2
12-27-2009, 07:49 PM
|
||||||
|
||||||
u need to reset the apps sensor
|
|
#3
12-27-2009, 07:50 PM
|
||||||
|
||||||
|
How about the connections between the APPS and the ECM? Kind of sounds like there is a connection that is being temporarily interrupted.
I have also heard that relocating the ground wire to/from the APPS can remedy throttle position issues, and TQ issues as well.
|
|
#4
12-27-2009, 07:52 PM
|
||||||
|
||||||
|
Clear the codes after you reset the APPS.
|
|
#5
12-27-2009, 07:52 PM
|
|||||
|
|||||
|
sensor has been reset quite a few times, it will also go like 2 or 3 hours of plowing running just fine
|
|
| Thread Tools | |
|
|
| Copyright And Legal Notice | Links Of Interest |
|
Powered by vBulletin® Version 3.8.6 
|
|
