So this weekend I installed my bhaf and made a heat sheild for it while the hose was off i noticed the shaft in the turbo has play in it. The fins are not rubbing the turbo is not making noise or anything it still wines up (can hear the turbo whine alot more with the bhaf sounds awesome love it) and can still feel the boost come on. I am worried about the play. My question is can i rebuild it myself, get a new one or what dont want to let it go too long the only thing is on a tight buget for a new one right now. So i thought rebuild might be the way to go? or do i just baby it a while will it be ok since it is not rubbing and just keep an eye on it so that it doent get worse. maybe a used one at the junkyard? and what do they go for new and used average? Thanks guys any help greatly appreciated. -

blkjack's Sig:

2002 Quad cab 2500 24v 6spd. Mods, 86d' Silencer ring, Turbo back 4" exhaust w/ 5" tip. Custom built bolt in gooseneck. Soon to come gauges, FP, Pyro, Boost. Air Dog 150. and a Adrenaline pulse tuner.

I got a new one for $339 on ebay. I'd look there first. my $.02 -

aguilar_15's Sig:

2001 Dodge 2500, ext cab, 6spd. long bed. completely stock-hopin for some slight upgrades in the near future.

!!TSU!!

play is allowed, how much play do you have?

i cant remember , but I think it is .004 is allowed up and down and .008 side to side, cant remember but will look it up tonight when i get home. -

you can get a rebuild kit for 40 bucks so if you have some knowledge in automotive than it will be easy -

hotcummins's Sig:

12v 5x18s injectors 191 delivery valves 3k springs aroura5000 single i built the all billet tranny and ats 5 disc converter #100 fuel plate fire ringed arp head studs timing 22.0 degrees tabbed kdp quick spool cam and exhaust manifold 5 inch turbo back exhaust w/ 6 inch tip afe intake k&n cold air water meth injection airdog2 165








http://www.dieseldawgs.com/

It it axial play? Or in-out play? There is a maximum spec for in-out tolerance allowed. No axial play allowed. -

I dont have much play up and down it feels like about that much.


Thats what i wanted to know if i could rebuild one. and i do have some automotive knowledge i worked in a general autmotive shop for 9years am a ASE cert tech. but never messed with turbos much as far a rebuilding them just replaced with new or remans.

and i didnt think that up and down play was allowed with them -

end play min .001
max .003

radial clearance min .012
max .018

this is out of section 10 b series shop manual

the kits are fairly cheap, and they are not that hard to rebuild, just take your time. -

Ok thanks Cummins guy i will measure my clearances and then go from there. going to order one of the shop manuals today the actual shop manuals not the cheap everyday ones that you get from the parts store. I think that i seen that genos has them. -

I would run it until you notice it rubbing the housing. There will always be some play in a cartridge bearing turbo due to the necessary oil clearance -

Bosshogg's Sig:

02.5 2500 4X4 reg cab white HO 6spd. Tapped Edge Comp with TST plate and Bosch RV 275 sticks. Stacks by me to roll the coal. Walbro lift pump/filter big line setup, Multi function shifter stick, Solenoid High Idle. LED's All over it
Black smoke is just advertised horsepower!!!