98 24V cummins alternator external sensor
#1
98 24V cummins alternator external sensor
My 98 24v alternator quit but tests good.Charges if hooked to positive wire from battery.
The hot from the switch doesn't turn on [or from ecm]. Was told sensor in ecm is bad.
Got an external sensor to by pass the one in ecm.There a vague instructions and say not to hook old wiring up again to side post of alternator which were the hot and ground.Do i need to run a hot wire from switch? or will that continue charging?
Need help on how to install or which wire should be hot.
Thanks
The hot from the switch doesn't turn on [or from ecm]. Was told sensor in ecm is bad.
Got an external sensor to by pass the one in ecm.There a vague instructions and say not to hook old wiring up again to side post of alternator which were the hot and ground.Do i need to run a hot wire from switch? or will that continue charging?
Need help on how to install or which wire should be hot.
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
Shun70
Dodge Truck and Cummins Turbo Diesel Forum
1
09-20-2015 10:52 PM