2001 24 valve wont starr
#1
2001 24 valve wont starr
Hi I'm new here I have a big problem I shut off my truck and then went back later to start it and it cranks good just won't start I have between 15 and 18 psi on fuel new lift pump and about a year old in pump I have check all grounds check the ecm have power to it and power leaving going to sensors I can disconnect the in pump and put 12 volt to it and it will start right up and idle I don't know what is else to try before I just start buying parts any help would be appreciated
#5
Thanks have done that and I can make it run by putting 12 volt directly to the inj pump with a inline fuse and make the truck idle when I installed the plug back on the in pump it just cranks I have checked the voltage on the 50 pin connector on the ecm for grounds and 12 volt all there and have 5 volt leaving the ecm to the sensors have 2 volts on the buss and know im lost don't know where to go from here
#6
#7
Thanks for the help finally found the problem it was the fuse for the door locks it some how ties in to the anti theft took it to the shop and the scanner said fuel was shut off due to anti theft put the fuse in and started right up hopefully this will help someone else if they have the same problem
Thread
Thread Starter
Forum
Replies
Last Post
Bill in Ballard
Ford 83-94 6.9 and 7.3L General
3
03-13-2016 07:42 PM
bonestock
24 Valve 2nd Gen Dodge Cummins 98.5-02
0
02-01-2015 08:41 PM