2002 auto with blown motor swap 1990 motor and 5 spd
#1
2002 auto with blown motor swap 1990 motor and 5 spd
I had a 1990 cummins with a 5spd that needed more work than it was worth. Bought a 2002 cummins auto. The motor was built up to over 500 Hp but didn't hold and the guy lost interest or his Dad ran out of $$. The trans was built to handle the power. I'm planning to put the motor and trans out of the 1990 into the 2002. If you have experience with this kind of swap I'm interested in hearing what you have learned.
Thanks for any imput
Thanks for any imput
#2
it should be an easy swap. Just put it in like your were putting it in a chevy chassis or such. You would have to figure out the sensors for the guages and such. SInce I am 90% sure the guages are run into the ECM, then to the dash. unless you find thatstuff from like a 98.5 and down. since they are factory 12v and no electronics like the 02.
So is the 02 4wd or 2wd. If it had a built trans, what going to happen with it?
So is the 02 4wd or 2wd. If it had a built trans, what going to happen with it?
Last edited by BarryB; 06-18-2013 at 04:48 PM.
#3
#4
That shouldn't be to bad to do. Find a manual truck and get the pedals from it. Doesn't have to be a diesel truck for that.
---AutoMerged DoublePost---
Is the 90 a hydro cluch linkage? If so, Then that shouldnt be real bad .
---AutoMerged DoublePost---
Is the 90 a hydro cluch linkage? If so, Then that shouldnt be real bad .
Last edited by BarryB; 06-18-2013 at 08:53 PM. Reason: Automerged Doublepost
#5