how to install running lights
#4
very simple...remove headliner. use the pre existing holes in the inside roof panel to line up your holes...thats what i did with mine. or use some kind of stencil to measure out your lights on the roof. drill holes for wires. i used some rvt silicone on my lights to seal between the light and the roof. run the wires thru and screw them down. then run the pos and neg's to the left side of the truck and ground the ground wire. run pos wire down a pillar to parking light switch and connect. and thats about it.
Thread
Thread Starter
Forum
Replies
Last Post
carid
Diesel Bombers Sponsors
0
01-06-2015 06:28 AM