manual to an auto??? any info on controls
#1
manual to an auto??? any info on controls
alright i boght another cummins and this one was a 5 speed but in the deal the guy already sold the manual tranny, and had a 47RH so my question is... what wiring do i need to add for the truck to be able to run the trans as i am keeping the manual steering coulmn and putting a ratchet shifter into it linkage will not be a problem.. do i just have to run my tranny pigtails from the tranny to the throttle positioning sensor or??????????? please help im stuck..
#3
#4
with a 47 rh you only have a 3 pin wire connector, the middle pin would have to be hooked to a 12v ing. source and the two pins on either side are for lock-up and od, mine is wired like this-the od pin is hooked to a high beam on and off switch mounted to the floor board just under the e-brake, the other side of the switch is grounded, the lock-up switch is a monetary switch on a relay hooked to the brake light switch so that when you step on the brakes it comes out of lock-up
both switches have to ground out the pins to complete the circut
both switches have to ground out the pins to complete the circut
#5
Thread
Thread Starter
Forum
Replies
Last Post
1ATony
1A Auto Parts
1
11-11-2015 10:03 AM