tranny exchange cooler
#1
tranny exchange cooler
im in the process of rebuild my two forward clutch packs and putting a shift kit in the vb, i bought a new sonnax manual valve that will allow the tc to charge while in park, the directions say to remove the check valve that is below the tranny exchange cooler so that the tc doesnt shudder and what not, im thinking about deleting the whole thing all together, ideas on this??? good or bad?
---AutoMerged DoublePost---
im taking about the tranny fluid to engine coolent exchange cooler that is located on the side of the block under the turbo, it allows that tranny fluid to heat up to the engine temp so they run roughly the same
---AutoMerged DoublePost---
im taking about the tranny fluid to engine coolent exchange cooler that is located on the side of the block under the turbo, it allows that tranny fluid to heat up to the engine temp so they run roughly the same
Last edited by cumminspwr11; 09-02-2010 at 12:21 PM. Reason: Automerged Doublepost
#2
#3
i already have one off a 6.0 mounted up under the bed side with daul 10" fans, the cooler its self is 3/4" thick by 18" long and 12" tall
---AutoMerged DoublePost---
should i plug off the engine cooler lines or loop them together?
---AutoMerged DoublePost---
should i plug off the engine cooler lines or loop them together?
Last edited by cumminspwr11; 09-02-2010 at 08:18 PM. Reason: Automerged Doublepost
Thread
Thread Starter
Forum
Replies
Last Post
Bighouse
Ford Powerstroke 03-07 6.0L
1
04-09-2015 06:51 PM
mcompton1973
Ford Powerstroke 99-03 7.3L
1
02-11-2015 12:00 PM