How to remove cam (part way)
#1
08-20-2010, 01:14 AM
How to remove cam (part way)
As always ~ SAFETY FIRST!!
- Disconnect the Negative cable of your battery system.
- Chock the wheels and set the parking brake.
- Have a known good fire extinguisher close by.
- Have good lighting.
- Have a clean and orderly work area.
- Always exercise good working practice with your tools.
- Use safety goggles, gloves, masks, etc where appropriate.
Remove the dampner
Remove the bolts in gear cover and remove the gear case (note blown seal)
Remove the tap-it cover
align the timing markes
Remove the cam retainer bolts
This is a hard part you have to hold up the tap-its I used a pare of plyers and pulled each one while putting psi on the cam
Rotate and remove the cam tap-it by tap-it and set on floor (standing up an tie to something so it wont fall over)
(More to come)
- Disconnect the Negative cable of your battery system.
- Chock the wheels and set the parking brake.
- Have a known good fire extinguisher close by.
- Have good lighting.
- Have a clean and orderly work area.
- Always exercise good working practice with your tools.
- Use safety goggles, gloves, masks, etc where appropriate.
Remove the dampner
Remove the bolts in gear cover and remove the gear case (note blown seal)
Remove the tap-it cover
align the timing markes
Remove the cam retainer bolts
This is a hard part you have to hold up the tap-its I used a pare of plyers and pulled each one while putting psi on the cam
Rotate and remove the cam tap-it by tap-it and set on floor (standing up an tie to something so it wont fall over)
(More to come)
Thread
Thread Starter
Forum
Replies
Last Post
Jet A Fuel
Tech Article Submission
0
06-05-2015 03:55 PM
Jet A Fuel
Tech Article Submission
0
06-05-2015 03:28 PM
Diesel Bombers
General Diesel Related
0
03-04-2015 08:20 AM
