2009 track bar with conversion kit!?!?!?!?!?
#1
2009 track bar with conversion kit!?!?!?!?!?
[Hi all i am going to order a conversion bracket so i can put a 3rd gen trackbar on my truck but I have one question i went to my local junk yard and got a track bar off an 09 cummins now is this trackbar the same as 03-07 models? From what I can see it is, but I just want to be absolutely sure. Any and all help is appreciated
#2
The following users liked this post:
new12vguy (10-14-2013)
#3
Finally! Thankyou
---AutoMerged DoublePost---
Oh I see your from las cruces! I am in el paso and frequent las cruces as with diesel shops I do not trust any here in el paso. Good to see a fellow member locally!
---AutoMerged DoublePost---
Oh I see your from las cruces! I am in el paso and frequent las cruces as with diesel shops I do not trust any here in el paso. Good to see a fellow member locally!
Last edited by new12vguy; 10-14-2013 at 01:44 AM. Reason: Automerged Doublepost
#4
03' - 07' used smaller bolts.
07.5' - 11' used a larger sized bolt at both ends.
Shape is the same. Since you found a track bar from an 09', you'll just need to open up the bolt hole on the axle side more, and maybe on the track bar bracket if it was built for the 03' - 07', but nothing that would take more than a couple minutes.
07.5' - 11' used a larger sized bolt at both ends.
Shape is the same. Since you found a track bar from an 09', you'll just need to open up the bolt hole on the axle side more, and maybe on the track bar bracket if it was built for the 03' - 07', but nothing that would take more than a couple minutes.
The following users liked this post:
H.R.D (10-14-2013)
#5
03' - 07' used smaller bolts.
07.5' - 11' used a larger sized bolt at both ends.
Shape is the same. Since you found a track bar from an 09', you'll just need to open up the bolt hole on the axle side more, and maybe on the track bar bracket if it was built for the 03' - 07', but nothing that would take more than a couple minutes.
07.5' - 11' used a larger sized bolt at both ends.
Shape is the same. Since you found a track bar from an 09', you'll just need to open up the bolt hole on the axle side more, and maybe on the track bar bracket if it was built for the 03' - 07', but nothing that would take more than a couple minutes.
Good info.
Thread
Thread Starter
Forum
Replies
Last Post
CGwill
24 Valve 2nd Gen Dodge Cummins 98.5-02
0
01-26-2015 02:10 AM
TyCarp
24 Valve 2nd Gen Dodge Cummins 98.5-02
0
12-10-2014 11:02 AM