Any idea what this connects to?
#1
#2
#3
I will check that, That prompted me to look up the locations.
24 Valve Fuel System Components
I wonder if the 12 valve is the same or similar.
---AutoMerged DoublePost---
THis was the diagram I should have used..
http://www.dodgeram.org/tech/dsl/Fac...ocations-l.gif
24 Valve Fuel System Components
I wonder if the 12 valve is the same or similar.
---AutoMerged DoublePost---
THis was the diagram I should have used..
http://www.dodgeram.org/tech/dsl/Fac...ocations-l.gif
Last edited by pwcracer; 03-27-2013 at 09:47 AM. Reason: Automerged Doublepost
#4
#6
I have no oil pressure on the gauge, but the stupid thing is, I am not sure if it worked to start with. I bought the truck last fall as a basket case, and really don't remember.
I can not find the oil sender on this thing. I even looked around with a mirror. I have taken a ton of pics, hoping someone can help. (Where I think the oil pressure sensor should be, is a rounded off button sore of thing)
The connector wire seems to be 2 yellow wires.
here is what it plugged into
This is where I thought the OPS would be
[IMG]http://i1296.photobucket.com/albums/ag13/Gbfan55033
/20130327_220658_zps75066a1a.jpg[/IMG]
Other end of broken sensor.
??
I can not find the oil sender on this thing. I even looked around with a mirror. I have taken a ton of pics, hoping someone can help. (Where I think the oil pressure sensor should be, is a rounded off button sore of thing)
The connector wire seems to be 2 yellow wires.
here is what it plugged into
This is where I thought the OPS would be
[IMG]http://i1296.photobucket.com/albums/ag13/Gbfan55033
/20130327_220658_zps75066a1a.jpg[/IMG]
Other end of broken sensor.
??
#9
that is the oil pressure "switch" per the Cummins Tech that helped me with mine. They call it a sending unit but it is a switch. When you have oil pressure the switch closes and sends the current to the PCM the PCM then uses the signals from the engine speed sensor and "calculates the pressure info that it sends to the Oil Pressure Gauge. In all this there is no actual measurement of pressure. You can get one from Auto Zone for around $34. and the have a sensor socket that will make it easier. I had to break off the plastic part to get the socket to go on the old one but it fit over the new one perfect. IT IS A VERY FINE THREAD SO START IN CAREFULLY BY HAND. It is directly between the fuel prescreen and the Canned Ham Pump
Hope this helps you
---AutoMerged DoublePost---
stick your camera phone and movie the area and you should see it or rather half that is left.
Hope this helps you
---AutoMerged DoublePost---
stick your camera phone and movie the area and you should see it or rather half that is left.
Last edited by NEWBIE 98; 03-28-2013 at 08:58 PM. Reason: Automerged Doublepost